Feedback - woodbridgebath.com

Smart Toilet

B0970S-3.0

How to turn on/off the auto flush function?

Long press “FULL FLUSH” button to turn on/off auto flush function. When the auto flush function is on, when it's detected that the user is seated for above 6s and leaves the seat for above 3.5s, it will flush automatically.

If it still doesn't work, restart the toilet and reset the function. （Restart steps: Unplug the power cord of the unit for 30 seconds and then plugging it back in. Once you plug it back in press the reset button at the end of the power cord.)

Weak Flush

Sometimes the unit has too much water going to the unit, affecting the flushing in a negative way. So what you can try doing is reducing the water pressure going to the unit, on the angle valve there is a knob. First turn the knob slightly about 5-10% of the way closed, the most you want it is about 75% of the way closed. But you do want to play with the amount of pressure and see if this fixes the issue, try not to close it more than 20% of the way, unless needed(ALSO DEPENDS ON YOUR ANGLE VALVE, YOU MIGHT BE ABLE TO TURN IT 75% OF THE WAY SHUT). After each adjustment, you also may have to leave it in the adjusted position for a couple minutes before attempting to flush, and then flush multiple times to test the flushing. So let's say you adjust the angle valve to be 50% of the way closed and then it begins to flush properly, then you'd leave it in that adjusted position.

If it still doesn't work, please email to help@woodbridgebath.com. We will reply within 2 working days. Thank you.

How to do the remote matching?

The user code needs to be set to avoid disturbance from remote controls when more than one smart toilets are used in the house.

Turn on the toilet for setting while turning off others. Press user code combination buttons (Press“STOP” button first and then press “REAR” button) to enter user code setting mode, the indicator lights will be on and keep flashing.

Press water volume “+”“-” buttons to select user code. The indicator shows the corresponding user code.

Press the user code combination buttons again to save settings and exit. The buzzer beeps and it's set successfully.

When the main unit is powered off to restart or batteries are removed from remote control, the user code will be cleared and need to be reset. After entering setting mode, if there's no operation for 10s, the remote control will exit setting mode automatically and return to previous states.

How to turn on/off the Automatic pre-wetting function?

Press and hold the "STOP" button and press the "DRYER TEMP" button to turn on or off the automatic pre-wetting function.

After the automatic pre-wetting function is turned on, the pre-wetting function is performed when the user is detected to be seated.

If it still doesn't work, restart the toilet and set up the function again. （Restart steps: Unplug the power cord of the unit for 30 seconds and then plugging it back in. Once you plug it back in press the reset button at the end of the power cord.)

How to turn on/off the night light?

Short press“Night light”button to turn on/turn off night light,

Long press“Night light”button to enter into intelligent mode ( Night light will be on or off by detecting the lightness of surroundings). If the product is on intelligent mode, short press“Night light”button to exit intelligent mode.